The spots on the bathroom ceiling come back every January no matter how many times you wipe them, and this year the drywall behind the vanity is soft where the supply line comes through the wall. This site connects you by phone with an independent local provider who does bathroom mold removal in Carson City and the Carson Valley. It is the most common first call from the older homes here.
The crew reads the ceiling, the wall behind the vanity, and the floor around the toilet and tub with a moisture meter. They check whether the exhaust fan actually moves air, where it vents, and whether the supply and drain lines under the vanity are wet. In most Carson City bathrooms the answer is two problems at once: a fan that vents into the attic or does not run, and a slow leak at a fitting nobody sees.
Containment for a bathroom is simple because the room is small. Plastic seals the doorway, a HEPA air scrubber runs as negative air, and the heat register is covered.
Stop wiping the ceiling. Wiping a soft, stained ceiling spreads the growth and does nothing for the moisture. Run the fan, or open the window if there is no fan, after every shower until the crew comes. If the wall behind the vanity is wet, shut the angle stops under the sink and check the floor of the cabinet.
Do not paint over it. A coat of bathroom paint over active growth is a stain that comes back in a month.
Ceiling drywall with growth through it comes out, along with any wet insulation above it. The wall behind the vanity is opened and the wet drywall removed; the vanity itself comes out if the particleboard bottom has swollen. Tile, tub surrounds, and grout are cleaned and stay unless the wall behind them is wet.
After removal the crew HEPA vacuums and wipes the room, dries the framing, and fixes the moisture: the leak, the fan, or both. A fan that vents into the attic gets rerouted through the roof or the soffit, because a bathroom fan dumping steam into a Carson City attic all winter is how attic mold remediation starts. New drywall, paint, and the vanity going back is mold damage repair.
Bathroom ceilings here grow mold in winter, not summer. The shower puts out warm, wet air, the ceiling above it is cold because the attic is cold and the insulation is thin, and the water condenses on the drywall every morning from December through March. A working fan and a lid of insulation above the room solve more of these than any cleaning product.
The older houses on the West Side and the 1950s to 1970s ranches in north and south Carson often have galvanized supply lines and original angle stops, and the slow drip at the wall is a steady source of calls. In a house over a crawl space, that drip runs down inside the wall and into the joists below, so the crew should check under the bathroom before writing the scope.
Nevada issues no separate mold license. A plumber who fixes the leak and a contractor who rebuilds the wall each hold their own license with the state, and you can look them up. Putting the drywall and vanity back may need a permit through the Carson City Building Division or the county, depending on what is replaced.
Have the address, whether the growth is on the ceiling, the wall, or under the vanity, and whether the fan works. Say if the wall is soft. Call (775) 242-6705.
Standing bySay where you smell it or see it. The call is routed to an independent local provider who handles mold removal and remediation in your part of Carson City or the Carson Valley.
Roof-deck and rafter mold from ice dams, swamp cooler lines, and warm indoor air hitting a cold roof, cleaned and the cause corrected.
Drywall, baseboard, subfloor, and cabinet bottoms put back after removal, only once the framing reads dry and the leak is stopped.
Finding and removing the damp material behind a musty smell that outlasted cleaning, then treating surfaces and air so it stays gone.